: 1080x760 px
: June 29, 2018
Between the electrolyte and the lead plates, a chemical reaction is created. This produces dangerous, explosive gases that vent through the battery cover vents. Because of this, caution should be taken when you charge or jump start a low battery. The same caution should also be taken every time you are working under the hood of your vehicle. It is important to provide as good ventilation as possible in the battery, so always keep it clean.
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.