: 1062x1280 px
: July 7, 2018
If your vehicle does not use an automatic tensioning device, then check belt tension as follows: With the engine turned off, grasp the belt at a convenient point about 8 to 10 inches from the alternator pulley. Move the belt slowly up and down. The belt should not move more than about 12 inch. If the belt seems to be excessively loose, then of course it will require tightening andor replacement.
Use your multi-meter to probe each connector. Set the multi-meter for DC volts and put the prongs of your multi-meter into the connector. It should read 12 volts. Check the wiring on any switch that has a low voltage reading. Tighten any loose connections, and clear away any corrosion. Test another switch. Take a switch from another door and plug it into the connectors on the malfunctioning door. If you are able to operate your window using this switch, then the original is bad and will need to be replaced. Buy a new switch. Contact your dealership or favorite parts store and get a new window switch. Install the new window switch. This can be done by plugging the connectors into the switch and popping the switch back into the door panel.