: 1200x896 px
: June 24, 2018
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.
Use your multi-meter to probe each connector. Set the multi-meter for DC volts and put the prongs of your multi-meter into the connector. It should read 12 volts. Check the wiring on any switch that has a low voltage reading. Tighten any loose connections, and clear away any corrosion. Test another switch. Take a switch from another door and plug it into the connectors on the malfunctioning door. If you are able to operate your window using this switch, then the original is bad and will need to be replaced. Buy a new switch. Contact your dealership or favorite parts store and get a new window switch. Install the new window switch. This can be done by plugging the connectors into the switch and popping the switch back into the door panel.