: 1224x792 px
: July 2, 2018
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.
Replacing a Faulty Switch: Locate the window switch panel. This is the button used to operate your window. It is almost always on the door, however, they are rarely found on the center console. Remove the window switch panel. Be careful not to scratch up the door panel while removing the window switch, as it often requires prying. Using a shop rag or piece of cardboard under your prying tool can help. Unplug the wiring connectors from the switch. You will need to test these connectors to make sure that they are providing the appropriate 12 volts to your switch.