: 1600x1600 px
: July 1, 2018
Use your multi-meter to probe each connector. Set the multi-meter for DC volts and put the prongs of your multi-meter into the connector. It should read 12 volts. Check the wiring on any switch that has a low voltage reading. Tighten any loose connections, and clear away any corrosion. Test another switch. Take a switch from another door and plug it into the connectors on the malfunctioning door. If you are able to operate your window using this switch, then the original is bad and will need to be replaced. Buy a new switch. Contact your dealership or favorite parts store and get a new window switch. Install the new window switch. This can be done by plugging the connectors into the switch and popping the switch back into the door panel.
If your motor is functioning properly but the window is not responding, you may need to replace your regulator. Remove the bolts that attach the regulator to the glass. The regulator is the lift assembly that moves your window up and down. You will have to move the window up or down to align these bolts with a hole in the door interior. Using an extension on a ratchet, you will put a socket (usually 8 or 10 mm) through the hole and loosen the two bolts. Push the window all the way up. Use your hands to push the window up, and then either fasten it with tape or pull it out of the door altogether.