Here's what causes this: A blown fuse for the system, A wheel-speed sensor that is damaged or covered by road grime, A broken wire between the sensors and the ABS controller, An ABS controller that has stopped working. A pump and valve that apply the right amount of brake fluid pressure to each wheel to prevent locking can also trigger an ABS sensor warning light when those items go bad. If the red warning light for the regular brakes comes on, that typically means your vehicle is losing brake fluid or the brakes are so worn that you don't have normal stopping power. Either of those situations warrants immediate attention and possible repair work.
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.
An auto battery is built up of six cells, each containing stacked positive and negative lead plates. These are divided and separated by insulators and immersed in an electrolyte, a liquid blend of sulfuric acid and water. However, some batteries, use a gel instead of the electrolyte. This is considered to be safer and because you do not have to refill it with electrolyte, it has been labelled "maintenance-free". Each cell generates or more correctly put, stores 2.1 volts for a total of 12.6 volts.
Changing a Fuse: Locate and open the fuse box.It should be located inside the car as a part of, or near, the dash. Check your owner's manual to locate that operates the windows. It is not uncommon that the only thing wrong with electrical components in a vehicle is a blown fuse. If this is the case with your windows you will need to replace the window fuse. Pull the fuse straight out of its cradle. Be careful not to twist or otherwise force it. You do not want to damage the cradle or break a piece of the fuse off in the cradle. There are fuse tongs available at part supply stores that can help with this.