: 1200x900 px
: June 26, 2018
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.
These can often be difficult to bolts to remove. You may need to use a ratchet with a long extension to provide the necessary angle to access and turn the bolts. Pull the motor and harness out as one assembly. Once you have the assembly removed, you can separate the two pieces and replace the one that is malfunctioning. Re-install the motorregulator assembly. Once you have replaced the malfunctioning part, whether it was the motor or the regulator, it is time to slide the assembly back into the door's interior and bolt it back into it's original position.