: 1800x1800 px
: June 26, 2018
If your vehicle does not use an automatic tensioning device, then check belt tension as follows: With the engine turned off, grasp the belt at a convenient point about 8 to 10 inches from the alternator pulley. Move the belt slowly up and down. The belt should not move more than about 12 inch. If the belt seems to be excessively loose, then of course it will require tightening andor replacement.
Use a multi-meter to confirm that the switch is getting 12V of power. Attach the leads of the multi-meter to where the electrical wires come into the switch and set the meter to DC volts. It should read 12 volts. Trace the wiring from the switch to the motor. This is the path that a signal will travel to move your window when you press the switch. Any breaks or loose connections in this path will prevent your motor from functioning properly. Use the multi-meter to confirm that the motor is getting 12V of power.