: 1024x917 px
: May 27, 2018
Replacing a Faulty Switch: Locate the window switch panel. This is the button used to operate your window. It is almost always on the door, however, they are rarely found on the center console. Remove the window switch panel. Be careful not to scratch up the door panel while removing the window switch, as it often requires prying. Using a shop rag or piece of cardboard under your prying tool can help. Unplug the wiring connectors from the switch. You will need to test these connectors to make sure that they are providing the appropriate 12 volts to your switch.
Attach the leads of the multi-meter to where the electrical wires come into the motor. Again, set it to DC volts and it should read 12 volts. Look for any interrupted voltage caused by a loose connector or corrosion. If there are any loose or corroded connections in the circuit they will disrupt the signal and cause your window to malfunction. Fix the connector or corroded areas. Push any connectors or wiring harnesses together tightly, and clean any corrosion away with a wire brush or similar tool. Test the window again. If your problem was in the circuitry and is now fixed, then your window should freely roll up and down without any restrictions or delays.