: 1000x877 px
: June 23, 2018
Plug up the new motor. Plug the wiring harness into the window motor. This will provide power to the motor so use caution. Lower your window back into its correct place on the wiring harness. Remove the tape or re-install your window. Make sure that the tabs in the bottom of the window are properly aligned to bolt it back onto the regulator. Bolt the window to the regulator. Using the bolts you removed earlier and the same extension, you need to bolt your window back to the regulator. Test your window. It should now move up and down freely when you press the switch.
Starter: starting the car was a sweat-breaking business before the starter. A procedure by it's own, where you had to be fairly skilled. Cranking the car was done with a cranking rod. The driver would put it into place, use all the strength available, crank the engine and if he's lucky the engine would start after a few turns. If not, he was in for another lesson in body-building. Aside that, when the engine started the driver had to let loose of the rod in time or else he would get a knock in the face. Every time you put the key into the ignition, remember this and enjoy it as a privilege.